Have a commercial kegerator? Looking to easily switch between commercial and homebrew kegs? The default quantities above have everything you need to easily swap between an already existing Sankey tap and ball lock kegs. You will have to remove the tailpieces from your liquid and gas lines and replace them with the barbed swivel nuts. Then install the 1/4" mfl tailpieces on your Sankey tap. The barbed swivel nut can easily be attached to either the Sankey tap or the 1/4" mfl Ball Lock Disconnects; make sure to use the nylon washers for the best connection. If your Sankey tap does not have a beer shank nut and washer for the liquid side (some new ones don't) you'll need to add one of each. This kit may not work on all Low-Profile Sankey taps, but any normal Sankey tap is fine. Instructions can be found here.