Low Profile Sankey Coupler

It is a beutiful product that is super easy to use. Purchased for the kegerator and it works perfect.

This is awesome for your kegerator, saves space!!

I have two of these now in my keezer, they're the only way I can get a commercial keg to fit. I can easily fit a combination of up to three of any type 1/6 commercial kegs and pin lock kegs. I have taken the barbs off of both of mine and bought stainless 1/8" NPT-1/4" MFL from McMaster Carr so that I can easily swap out lines with either the commercial couplers or homebrew couplers.

I have a height-issue in my kegerator as well so I picked up this coupler. I used it for the first time last night and it was wonderful! I think it was easier to use than some of the other commercial couplers I have used in the past. Easy to attach/remove from the keg, no leaks, etc.I have 1/4" gas lines and was worried I would need to retrofit one of them to 5/16". The 1/4" ID line DOES fit tightly around the barb which was a nice surprise.

Out of all the things I've purchased from Northern Brewer - this may easily be the most underrated thing I've picked up. I have a fairly generic 9 cu. ft kegerator setup - which works great for homebrew, but commercial kegs were always a tight fit with a standard sanke tap. This product saved me about 3 inches from the lid over the standard tap - 2 inches on height alone and then another inch on the tightest bend I could get in my beer lines while still dispensing. I was worried about missing something without a locking handle, but then I found out this whole unit rotates and locks in place. Finally, I no longer have to go out with guests to the kegerator to make sure they don't pinch any lines or snap off a pressurized line.