Brass Cooler Valve Kit
Valve assembly with brass 1/2" ball valve. Fits most cylindrical coolers; maximum cooler wall thickness is about 5/8".
Proposition 65 Warning for California Consumers: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.
as advertised. worked great.
This is a good quality valve that gets the job done. Installation was simple in a 5 gallon igloo cooler. No modification necessary, just remove the plastic cooler valve and install the new one. Not as pretty as the stainless valves out there, but not nearly as expensive either. Personally, I'd rather spend my brewing money on ingredients than hardware
It does everything a valve should do. It doesn't leak, it opens, it closes, and it pretty easy to adjust the flow rate. Like the other reviewer mentioned, you have to hold it to open the valve without spinning the bulkhead.
Worked well with Home Depot 10 gallon cooler. I bought two to use with two coolers.The coolers don't have a whole lot of support for the ball values, and there handles do take a little force to move. Because of that, you should probably hold the ball valve when moving the handle.