Soda Keg CO2 Charger
Note: This charger is only compatible with 16-gram cartridges.
Uses disposable CO2 cartridges to dispense kegged homebrew on the go - leave the heavy CO2 tank and regulator at home. Attaches to the gas side of soda kegs; requires a 1/4" MFL gas disconnect (#K010 or #K036), not included.
Please note, we cannot ship this product internationally, by air, or by US Post.
Proposition 65 Warning for California Consumers: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.
Reservoir was to small for the standard CO2 cartridges that I had. I used some paper trowel to fill about a 1/4” of space then they would ‘seat’ Once seated the divine was awesome. I’d buy another one but having to jury rig a new device is annoying.
I am not impressed with this charging method. I don't know if mine is leaking but there is no way it will dispense my 1.75 gallon party keg. Definitely would not buy again!!
Works great. Although it did take me a minute to get the hang of it.
Be prepared when that CO2 or Nitrogen tanks runs empty on you but the party must continue. Slip one of these soda keg chargers on your rig and keep pouring. Saved my butt a couple of ties already. Just keep a couple of O2 or N2 cartridges on hand and you'll never stop pouring.
Got this from NB for Christmas, didn't come with any documentation but I didn't figure it was rocket science. Only problem was that I used a 16g CO2 cartridge (which looked like it was the right size for it) and when I screwed it down the cheap plastic on the bottom cracked and started bulging out. It still works as far as I can tell but doesn't look great. I used it on a one gallon soda keg and it seemed to work fine except I put too much pressure on it. Heading to the hardware store now to grab some fittings and a little pressure gauge to add on so I don't make that mistake again. Other than that I think it works as it should.